Pneumatic automation

Often, in the field of mechanical engineering, you have to face automation problems that require a high standard of reliability while maintaining low costs/moderate prices. The use of compressed air can be an effective and flexible choice, an extremely cheap/low-cost resource which can be found in every workplace and which often allows to find solutions that meet very well the requirements of automation.

In order to provide some suggestions, I thought I could devote some space to my notes of pneumatic automation, thus allowing the readers to ask for advice and add comments that may integrate the information contained in this section.

If you wish you can request quotes on components or advice about the design of systems that take into account your particular needs.

If you need expert advice, our work will be developed in three phases:

the first phase will consist of an interview/meeting at your office/headquarters in order to focus the objective to be achieved;
the second phase will involve the development, design and evaluation of costs;
during the third and last phase will deliver the required material and its documentation (with photos of the system set in motion and running at our workshop) that will allow you to successfully run the assembly.

Please do not hesitate to contact me if you have any question or specific request, either using the form found at this link or by writing an email to info@ferriadelio.it.

Continue

Shopping Cart

Pneumatic automation

Information

Customer Service

Extras

My Account